Diesel Glow Plug Delay - CrimeStopper CS-2015.FM.RevB Installation Instructions Manual

This new feature provides a solution for diesel vehicle without having to connect to the Glow Plug-"Wait to Start
Circuit". This may be due to a variety of reasons. If your vehicle does not have a viable "Wait to Start Circuit", or you
cannot locate and identify the circuit, then change your system to "Diesel Glow Plug Delay" mode. You can choose
from a selection of "pre-cranking" delay times. Once this mode is activated, the CS-2011RS/2015FM system will
NO LONGER monitor the PINK glow plug input wire and will use a delay setting chosen by the installer in the option
chart.
NOTES: This feature is OFF by default and must be programmed before use! Once this feature is turned ON, the
Pink Glow plug input wire is not used. The Remote start unit will always wait the programmed time before cranking
EVEN IF the glow plugs warm up first. There are 3 different Delay times available for use: 10, 20, or 30 seconds.
SEE OPTION PROGRAMMING CHART.
HOW TO USE THIS FEATURE:
1. See the "Programmable Options" section and change Option #18 from "Monitor Glow Plug Light" to one of the
delayed time values. (Default setting is to always monitor the PINK Glow Plug input wire.)
2. Once this option has changed the CS-2011RS/2015FM system will wait for the selected time before cranking the
engine.
This system has many installer programmable features as listed in the chart on following pages.
To Engage Option Programming:
1. Open hood (ground the Blue wire if no hood pin switch is installed)
2. Turn Key to the ON position
3. Press program / valet button 5 times, after a few seconds the unit will flash the lights 5 times.
4. Push the valet/program button [again] the number of times that corresponds to the option number desired (1 thru
20). You must get a light flash after each button press. See chart on next page for option list.
5. When you reach the desired programming level, Press button #1(Lock) or #2 (Unlock) to change the option.
(Options 17, 18, and 19 have selections for all 4 transmitter buttons.)
6. Turn Ignition OFF, Close hood and check for changed features. Change each option individually repeating #1-5.

DIESEL GLOW PLUG DELAY

PROGRAMMABLE OPTIONS