Table of Contents
Advertisement
8
en | Configuration via IP, Basic Mode
4
Configuration via IP, Basic Mode
4.1
Basic Mode: Device Access
Camera name
You can give the camera a name to make it easier to identify. The name makes the task of
administering multiple units in larger video monitoring systems easier, for example using the
Bosch Video Management Systems programs.
The device name is used for the remote identification of a unit, in the event of an alarm for
example. For this reason, enter a name that makes it as easy as possible to quickly identify the
location.
Caution!
Do not use any special characters, for example &, in the name.
!
Special characters are not supported by the system's internal recording management and may
therefore result in the Player or Archive Player being unable to play back the recording.
Confirm password
In each case, enter the new password a second time to eliminate typing mistakes.
Notice!
A new password is only saved when you click the Set button. You should therefore click the
Set button immediately after entering and confirming a password.
4.2
Basic Mode: Date/Time
Device date/Device time/Device time zone
If there are multiple devices operating in your system or network, it is important to
synchronize their internal clocks. For example, it is only possible to identify and correctly
evaluate simultaneous recordings when all units are operating on the same time. If necessary,
you can synchronize the unit with your computer's system settings.
Notice!
Ensure that recording is stopped before synching to the PC.
4
Time server IP address
The camera can receive the time signal from a time server using various time server protocols,
and then use it to set the internal clock. The unit polls the time signal automatically once every
minute.
4
Time server type
Select the protocol that is supported by the selected time server. Preferably, you should
select the SNTP server as the protocol. This supports a high level of accuracy and is required
for special applications and subsequent function extensions.
Select Time server for a time server that works with the protocol RFC 868.
4.3
Basic Mode: Network
The settings on this page are used to integrate the camera into an existing network.
2015.03 | 1.0 |
Click the Sync to PC button to copy your computer's system time to the camera.
Enter the IP address of a time server here.
Operation Manual
EXTEGRA IP 9000 FX
Bosch Security Systems
Advertisement
Table of Contents
