Lens Settings - Bosch EXTEGRA IP 9000 FX Operation Manual

22 en | Configuration via IP, Advanced Mode
Noise Reduction Level
Adjusts the noise level to the appropriate level for shooting conditions. Select a value between
1 and 5.
Intelligent Defog
With the Defog mode feature, visibility can be improved significantly when viewing foggy or
other low-contrast scenes.
–
–
–
5.15

Lens Settings

Autofocus
Continuously adjusts the lens automatically to the correct focus for the sharpest picture.
–
–
–
Focus priority range
(previously titled Near focus limit)
For indoor cameras, the default value is 10 cm.
For outdoor cameras, the default value is 3 m.
Focus polarity
–
–
Focus speed
Use the slider (from 1 to 8) to control how fast the Auto focus will readjust when the focus
becomes blurred.
Auto iris
Automatically adjusts the lens to allow the correct illumination of the camera sensor. This type
of lens is recommended for use where there are low light or changing light conditions.
–
–
Iris polarity
Capability to reverse the operation of the iris button on the controller.
–
–
Auto iris level
Increases or decreases brightness according to the amount of light. Type a value between 1
and 15.
IR focus correction
Optimizes the focus for IR lighting. Options are: On, Off (default).
Maximum zoom speed
Controls the zoom speed.
Zoom polarity
Capability to reverse the operation of the zoom button on the controller.
–
2015.03 | 1.0 |
On - Defog is always active.
Off - Defog is disabled.
Auto - Defog activates automatically as needed.
One Push (default; commonly called "Spot Focus"): activates the Auto Focus feature after
the camera stops moving. Once focused, Auto Focus is inactive until the camera lens
zooms again.
Auto Focus: Auto Focus is always active.
Manual: Auto Focus is inactive.
Normal (default): focus controls operate normally.
Reverse: focus controls are reversed.
Constant (default): camera constantly adjusts to varying light conditions (default).
If you select this option, the camera makes the following changes automatically:
– Gain Control: switches to AGC.
– Shutter Speed: switches to default.
Manual: camera must be manually adjusted to compensate for varying light conditions.
Normal (default): iris controls operate normally.
Reverse: iris controls are reversed.
Normal (default): zoom controls operate normally.
Operation Manual
EXTEGRA IP 9000 FX
Bosch Security Systems