Table of Contents
Advertisement
OPTION PROGRAMMING
OPTION DESCRIPTIONS - SEE CHART ON PAGE 8
4. DOOR LOCK WITH PASSIVE ARM
This option controls whether the doors will lock when Passive Arming occurs. Note: May increase the risk of locking
keys in the vehicle. Factory default setting is ON.
5. PARKING LIGHTS ON WITH DISARM
Keeps parking lights on instead of 2 flashes when system is disarmed to assist in locating your vehicle in a crowded
parking lot or structure. Light will stay on for 30 Sec. or until Ignition is turned on. Factory Default setting is OFF.
6. ACTIVE RE-ARMING
Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a door has not
been opened. This is handy if the vehicle is accidentally disarmed (via the Transmitter in your pocket) without you
knowing it. The Factory default setting is OFF.
7. DISARM WITH REMOTE OUTPUT 1
Controls whether the system will or will not DISARM when the trunk pop or AUX. feature is used. When the feature is
turned on the unit will DISARM when opening trunk or other AUX feature. Factory Default setting is ON
8. REMOTE OUTPUT 2 or M.A.P. SWITCH
This feature controls the alarm system's uses a second remote output or an output for Mobile Accessories Protection
controlled by Valet Park Mode. Factory setting is Remote Output 2.
9. DOOR/ZONE OPEN WARNING DELAY
This setting changes the delay time in which the alarm system begins to monitor the Door, Hood, or Trunk Zones. This
is helpful on vehicles with a delayed dome light to prevent the alarm from giving warning chirps due to the vehicle's
dome light staying on. Factory Default setting is 8 Sec.
10.VEHICLE ASSIGNMENT
This feature sets the control module to be a primary single alarm (VEH 1) or it will allow this system to be designated
as a second vehicle to another Rage System set as VEH 2. Additional steps are required to set up a 2 vehicle system.
See "2 Vehicle Programming" Section.
11. DOUBLE UNLOCK PULSE
The unit will send 2 unlock pulses when the #2 Unlock button is pressed. This feature may be required for interfacing
this alarm with an existing Factory Keyless Entry or Alarm system in a vehicle. These systems are found on some
Nissan, VW, Toyota, and Lexus vehicles. Factory Default setting is OFF.
Advertisement
Table of Contents
