Operation And Maintenance Guidelines - Superior WRE4536RS Installation And Operation Instructions Manual

Bottom
Door Rail
Ash Box
Center
Brick
Figure 27 - Installing Bottom Door Frame
6. Align bottom rail mounting holes with
holes at front of firebox and secure with
screws removed in step 5.
7. Place ash box in place. Replace center
ash refractory.
INSTALLING GLASS DOORS
Spring clips have been installed but some
adjustments may be needed. If doors do not
close properly or do not appear straight, see
Door Adjustment.
1. With bi-fold doors completely folded,
insert bottom pivot pin into pivot hole
located near bottom corner of front face
opening and swing door to vertical posi-
tion making sure top pins slide into door
track. Door is installed when top door pin
snaps into spring clip.
2. Repeat step 1 for remaining door.
If you find doors do not close properly or do
not appear level or straight, proceed with
section on door adjustment,

OPERATION AND MAINTENANCE GUIDELINES

GLASS DOORS
Glass doors are optional with the fireplace.
When fireplace is in operation, doors must be
fully opened or fully closed position only or a
fire hazard may be created (see Figure 30,
page 17).
A fireplace equipped with glass doors operates
much differently than a fireplace with an open
front. A fireplace with glass doors has a limited
amount of air for combustion.
127017-01A
GLASS DOOR INSTALLATION
Screws
Ring
Handle
www.SuperiorFireplaces.US.com
Continued
Fold Door
and Slide
Top Pins
Into Track
Figure 28 - Installing Bi-Fold Doors
DOOR ADJUSTMENT
Remove doors and slightly loosen lower pivot
clips and upper spring clips. Replace doors
and fully close them. Use 1/8" shims (any
material) to level doors. Once proper setting
is achieved, carefully open doors enough so
that you can access spring clips with a Phillips
screwdriver. Tighten screws. See Figure 29.
Figure 29 - Adjusting Bi-Fold Doors
Excessive heat within the fireplace can result if
too large a fire is built or if combustion air gate
is not completely open. The following tips should
be followed to assure that both the fireplace
and glass door retain their beauty and function
properly. Both the flue damper and glass doors
must be fully opened before starting fire. This will
provide sufficient combustion air and maintain
safe temperatures in firebox.
Spring
Clip
Insert Pin
into Spring
Clip
Insert
Bottom
Pivot Pin
into Hole
Pivot
Hole
Spring
Clip
17