Enter Shock Sensor Adjustment Mode; Adjusting The Shock Sensor Setting - Clifford Matrix 12.5x Installation Manual

Shock Sensor Adjustment
N N o o t t e e : : This procedure only adjusts the on-board Zone 2 shock sensor.

Enter Shock Sensor Adjustment Mode

IMPORTANT! The system must be disarmed, and doors and other protected entries
(zones 1 and 6) must be closed, and ignition (zone 5) must be off.
1. Press and hold
2. The system will emit 1 long chirp to indicate entry into shock adjustment mode.
3. The LED will illuminate continuously for the duration of shock adjustment mode.
N N o o t t e e : : When the shock sensor adjustment mode is entered, all other timers and operations are bypassed
until adjustment mode is exited.

Adjusting the Shock Sensor Setting

N N o o t t e e : : When adjusting the shock sensor, ensure that the vehicle's doors are closed.
1. I I n n c c r r e e a a s s e e S S e e n n s s i i t t i i v v i i t t y y —Press and release the
step. The siren will chirp 2-times for each step increased in adjustment. When the shock sensor
adjustment reaches maximum sensitivity the siren will emit 2 short chirps and then 1 long chirp.
2. D D e e c c r r e e a a s s e e S S e e n n s s i i t t i i v v i i t t y y —Press and release the
one step. The siren will chirp 1-time for each step decreased in adjustment. When the shock sensor
adjustment reaches minimum sensitivity (sensor is Off) the siren will emit 1 short and then 1 long
chirp.
36
and buttons for 4-seconds.
button to increase shock sensor sensitivity by one
button to decrease shock sensor sensitivity by
© 2006
Directed Electronics