Immobilizer Wire Connection Guide
Immobilizer Wiring Diagram
___
GREEN/BLACK
A
___
GREEN
B
___
GREEN/WHITE
C
Immobilizer Wiring Guide
The starter immobilizer harness can be installed as a normally open or normally closed circuit by
connecting the desired side of the three-wire immobilizer. Locate the starter wire, then cut it and
make connections as described in the following diagram. Connect wire C to the end of the wire that
is still connected to the ignition switch; connect A or B wire to the end of the wire that continues
to the vehicle's starter circuit.
Note: Factory default setting is normally closed, if wired for normally open you must change the
programming.
GREEN/WHITE
2006
©
Directed Electronics
Starter - Normally Closed (motor side)
Starter - Normally Open (motor side)
NORMALLY
GREEN/WHITE
CLOSED
GREEN/BLACK
NOT USED (87)
NORMALLY CLOSED (87A)
COMMON (30)
ON BOARD
IMMOBILIZER
Starter - Common (key side)
NORMALLY
OPEN
GREEN
NORMALLY OPEN (87)
NOT USED (87A)
COMMON (30)
ON BOARD
IMMOBILIZER
17