Makita HR5201C Instruction Manual page 9

007853
Loosen the six screws with a screwdriver and remove
the crank cap. Rest the tool on the table with the bit end
pointing upwards. This will allow the old grease to collect
inside the crank housing.
007854
Wipe out the old grease inside and replace with a fresh
grease (60 g; 2 oz). Use only Makita genuine hammer
grease (optional accessory). Filling with more than the
specified amount of grease (approx. 60 g; 2 oz) can
cause faulty hammering action or tool failure. Fill only
with the specified amount of grease.
007855
Reinstall the crank cap and tighten with the screwdriver.
Connect the connector and reinstall the handle.
2
3
1
007856
1. Control plate
1
1. Screwdriver
2. Crank cap
1
2
1. Hammer grease
1
1. Connector
2. Black
3. White
CAUTION:
Do not tighten the crank cap excessively. It is made
•
of resin and is subject to breakage.
Be careful not to damage the connector or lead
•
wires especially when wiping out the old grease or
installing the handle.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Bull point
•
Cold chisel
•
Hammer grease
•
Bit grease
•
Depth gauge
•
Blow-out bulb
•
Safety goggles
•
Plastic carrying case
•
Scaling chisel
•
Scraping chisel
•
Clay spade
•
Side handle
•
Side grip
•
SDS-Max Carbide-tipped bits
•
Bushing tool
•
Rammer
•
Core bit adapter
•
Core bit
•
9
or attachments
Only use accessory or
are