Handle Height - Snapper 7800604 Operator's Manual

Handle Height

1. Remove the wingnuts (A, Figure 4), washers (not
shown), and bolts from the right and left handle
brackets (B).
Note: Do not remove the lower set of handle hardware (D) .
2. Adjust the handle to a higher or lower height adjustment
hole (C).
3. Reinstall the bolts, washers and wingnuts removed in
Step 1.
Handle Height (optional quick-release)
1. Turn the knobs (A, Figure 4a) on either side of the lower
handle (B) to retract the locking pins. Align the lower
handle with the desired set of holes in the handle
brackets (C). Turn the knobs to release the locking pins
and secure the lower handle.
Note: Do not remove the lower set of bolts and nuts securing
the lower handle.
C
D
Figure 4: Adjusting the handle height
C
B
A
Figure 4: Adjusting the handle height (quick-release)
Assembly
A
B
7