Connecting Internal Headers; Front Panel Header - EVGA X99 User Manual

Connecting Internal Headers

Front Panel Header

The front panel header on this motherboard is used to
connect the following four cables.
PWRLED

Attach the front panel power LED
cable to these two pins of the connector. The Power
LED indicates the system's status. When the system is
powered on, the LED will be on.
Note: Some system cases may not have all four cables. Be sure to match the
name on the connectors to the corresponding pins.
PWRSW

Attach the power button cable
from the case to these two pins.
Pressing the power button on the
front panel turns the system on and
off rather than using the onboard
button.
HD_LED

Attach the hard disk drive indicator
LED cable to these two pins. The
HDD indicator LED indicates the
activity status of the hard disks.
RESET

Attach the Reset switch cable from
the front panel of the case to these
two pins.
Pin
1
HD_LED
3
2
PWRLED
4
5
RESET
7
6
PWRSW
8
No Connect 9
Empty 10
Signal
HD_PWR
HD Active
PWR LED
STBY LED
Ground
RST BTN
PWR BTN
Ground
+5V
Empty
- 8 -