Programming For The Manager Work Station (Mws) - Master And Satellite; Programming Of The Mws Terminal Number - Sharp UP-3515 Instruction Manual

9. Programming for the Manager Work Station (MWS)
– master and satellite
Manager Work Station (MWS) is the system that enables inline data communication between UP-3515 POS
terminals in the IRC system and a host P.C. via LAN interface.
For the setup of the Manager Work Station, please be sure to consult your authorized SHARP dealer.
The function of Manager Work Station:
1) Downloading of POS terminal data
2) Uploading of POS terminal data
3) Remote Job Entry (RJE) function
4) T-LOG function
5) MAIL MESSAGE function
6) Uploading of SD card data

(1) Programming of the MWS terminal number

The terminal number of MWS can be specified by the following procedure:
1.
Enter the PGM2 mode from the mode selection window.
2.
Select "2 SETTING" from the displayed menu.
The SETTING window will appear.
3.
Select "22 MWS CONFIG" from the displayed menu.
The MWS CONFIG window will appear.
4.
Touch the "IP ADDRESS 4" line and enter a terminal number (1-254) for a MWS terminal, and then
touch the [EXIT] key.
The DATA NOT SAVED SAVE IT? dialogue will appear.
• Entering a terminal number of the machine itself results in "ENTRY ERROR."
5.
Select "1.SAVE."
A terminal number for a machine in MWS must be different from its terminal number for the IRC
NOTE
system.
46
[Terminal PC]
[Terminal PC]
[Terminal PC]
[Terminal PC]
[Terminal PC]
[Terminal PC]