Table of Contents
Advertisement
CAUTION: PLEASE TAKE OFF THE
WARMING RACK WHEN USING THE
ROTIS BURNER. THE HIGH HEAT
COMING FROM THE ROTIS BURNER
MAY CAUSE THE WARMING RACK TO
BEND.
WARNING: IMPORTANT!
BEFORE LIGHTING...
Inspect the gas supply hose prior to
turning the gas "ON". If there is evidence
of cuts, wear, or abrasion, it must be
replaced prior to use. Do not use the grill if
the odor of gas is present. Only the
pressure regulator and hose assembly
supplied with the unit should be used.
Never substitute regulators and hose
assembly for those supplied with the grill.
If a replacement is necessary, contact the
manufacture for proper replacement. The
replacement must be that specified in the
manual.
Screw the regulator (type QCC1) onto the
tank. Leak check the hose and regulator
connections with a soap and water
solution before operating the grill.
OPERATING INSTRUCTIONS
GRILL LIGHTING INSTRUCTIONS
TO LIGHT THE GRILL BURNER:
Make sure all knobs are "OFF" then turn on
the gas supply from the LP tank. Always
keep your face and body as far from the
grill as possible when lighting.
Your stainless steel grill has an exclusive
patented built-in ignition. The igniter is built
in to the valve. To ignite each burner simply
push and turn the control knobs to the HI
setting, you will hear the valve click as it
sends a spark to the pilot flame. If the
burner does not light wait 5 minutes for any
excess gas to dissipate and then retry.
20
I21Y06P-2
Advertisement
Table of Contents
