Tone Control; Room - Denon AVR-1708 Owner's Manual

SB CH OUT
(for 2-channel sources)
Determine whether to use surround back speakers.
[Selectable items]
ON
: The surround back channel signal is played.
OFF
: The surround back channel signal is not played.
This operation can be performed directly pressing the SURROUND BACK
button on the main unit.
SUBWOOFER ATT.
Attenuate subwoofer level when using EXT. IN mode.
[Selectable items]
ON
: The input from the subwoofer channel is attenuated.
OFF
: The input from the subwoofer channel is not attenuated.
Usually use in this mode.
Set this to "ON" if the subwoofer channel level seems too high when
playing Super Audio CD.
Subwoofer
Turn subwoofer output on and off.
[Selectable items]
ON
: The subwoofer is used.
OFF
: The subwoofer is not used.
Default
Resets the settings to the default values.

Tone Control

Adjust the tonal quality of the sound.
Tone Defeat
Turn tone adjustments off.
[Selectable items]
ON
: Playback without tone adjustment.
OFF
: Allow tone adjustment (treble, bass).
The tone cannot be adjusted when in the DIRECT mode.
Bass
Adjust low frequency range (bass).
[Variable range] –14dB ~ 14dB
Treble
Adjust high frequency range (treble).
[Variable range] –14dB ~ 14dB
"Bass" and "Treble" can be set when "Tone Defeat" is set to "OFF" .
Room EQ
Select the desired room equalization target.
[Selectable items]
Audyssey
: Optimize frequency response of all speakers.
Audyssey Byp. L/R
: Optimize frequency response of speakers
except front L and R speakers.
Audyssey Flat
: Optimize frequency response of all speakers to
flat response.
OFF
: Turn equalizer off.
OFF Audyssey
Audyssey Flat Audyssey Byp. L/R
• When "Audyssey" is selected, "Audyssey Mult EQ" indicator lights
green.
• When "Audyssey Byp. L/R" or "Audyssey Flat" is selected, or when
the auto setup measuring results have changed, "Audyssey Mult
EQ" indicator lights red.
•"Audyssey" , "Audyssey Byp. L/R" and "Audyssey Flat" can be selected
after the auto setup procedure has been performed.
• If the settings of the speakers for which "None" has been determined
at "Auto Setup" are changed, "Audyssey" , "Audyssey Byp. L/R" and
"Audyssey Flat" cannot be selected and measurements have to be
taken again to include the newly-added speakers.
• When using headphones, "Room EQ" is always set to "OFF" .
ENGLISH