Table of Contents
Advertisement
Wall Installation Instructions
Installation Notes
Do not install the PDP in any location other than a vertical wall.
1
To protect the performance of the PDP and prevent problems, avoid the following
2
places.
• Do not install next to smoke and fire detectors.
• Do not install in an area subjected to vibration.
• Do not install in an area subjected to high voltage.
• Do not install near or around any heating apparatus.
Use only recommended parts and components.
3
Parts
(Wall attachment panel is sold separately. Check with your
Wall attachment panel
879mm(34.6 inches)
624mm
(24.5 inches)
bolt
Insulation holder
14
dealer)
Installing the Display on the Wall Attachment Panel
See the drawing of the wall attachment panel shown in page 14 to check for
1
the stability of the wall where the PDP is to be installed. If the wall is not
enough strong to support the PDP, strengthen the wall before installation.
Fix the wall attachment panel on the wall using bolts as shown in the following
2
figure: Fixing bolts must protrude from the wall appox. 0.6 inches.
Using the wall attachment panel, you may adjust the angle of the display from
3
0 to 20 degrees. The angle can be set in 5 stages with 5 degrees of distance
each, using the angle control holes on the sides of the panel.
When the angle
When the angle
has been set to 5
has been set to
degrees.
15 degrees.
Angle control holes
Continued...
When the panel
hasn't been tilted.
5 degrees of tilt
10 degrees of tilt
15 degrees of tilt
No tilt
20 degrees of tilt
15
Advertisement
Table of Contents
