Table of Contents
Advertisement
Connecting to a PC
Connection to a Macintosh PC may require an adaptor that fits the PC terminal.
PDP
or
Use the DVI-D
connection cable.
(sold separately)
DVI Cable
Video Cable
Audio Cable
DVI jack
(The actual config-
uration on your PC
may be different,
depending on the
model.)
Connecting a PC to the PDP
1
Connect a PC (15pin) cable between the Video Output jack(or DVI jack) on the PC and the
RGB IN(or DVI IN) Input jack (15p D-SUB) on the PDP.
2
Connect a Audio cable between the Audio (RGB or DVI) on the PC and the Audio L/R (RGB
or DVI) input jacks on the PDP.
To watch the PC screen:
1. Turn on your PDP, and press the Source button on the remote control.
2. Move the joystick up or down to select the "PC", then press the joystick to enter.
3. Turn on PC and check for PC system requirements. (Refer to pages 66 and 67
for PC system requirements.)
3. Adjust the PC screen. (Refer to pages 68 and 74.)
64
Power Plug
Ferrite Cores
(3301-001110)
PC
Pin Configuration
D-Sub Cable
• 15Pin Signal Cable (based on protruded pin)
Setting up Your PDP (Plug and Play)
Our adoption of the new VESA
Plug and Play solution eliminates complicated and time consuming
setup. It allows you to install your monitor in a Plug and Play compatible system, without the usual
setup hassles and confusion. Your PC system can easily identify and configure itself for use with your
display. This monitor automatically tells the PC system its Extended Display Identification data (EDID)
using Display Data Channel (DDC) protocols.
DVI-D Cable (Digital-Only Connector)
65
Advertisement
Table of Contents
