Crestron CT-1600 Operation And Installation Manual page 11

1600 series wired touchpanels
Hide thumbs Also See for CT-1600:
Table of Contents

Advertisement

Crestron Series 1600
Operations & Installation Guide - DOC. 5836A
Drywall Mounting
LARGE
MOUNTING
PLATE
SMALL
MOUNTING
PLATE
DRYWALL
1. Locate an area on the wall clear of studs, wires, and other obstructions.
2. Make a small hole near the middle of the designated site; verify
location is suitable.
3. Fasten cutout template (40048, supplied) to mounting surface; verify
that the template is level.
4. Cut out and remove the traced shape of mounting surface.
5. Drill four 5/16" through holes as marked on template. Refer to
"Appendix B: Cutout Detail of Supplied Template" on page 20 for an
illustrative reference.
6. Drill eight holes marked "A" with #20 drill. Refer to "Appendix B:
Cutout Detail of Supplied Template" on page 20 for an illustrative
reference.
7. Slide one large metal mounting plate through the opening and position
it inside along the top horizontal edge.
8. Position one small metal mounting plate along the outside top
horizontal edge so that it covers the two center holes marked "A".
9. Use two mounting screws to secure the large and small metal mounting
plates to the mounting surface.
10. Repeat steps 7 through 9 for the bottom horizontal edge of the opening.
11. Attach the network cable in the wall to the connector on the back of the
touchpanel. Refer to "Network Wiring" on page 5 for wiring details.
12. Position the touchpanel (less the "Designer Series" cover) into the
opening and secure with the four remaining mounting screws. Be sure
the touchpanel is positioned right side up.
13. Firmly press the "Designer Series" cover evenly onto the touchpanel.
Mounting the Tiltcase Model
The CT-1600 or LC-1600 can be placed on or mounted to a flat surface. There are
mounting holes on the "foot" of the touchpanel to secure the panel in a fixed
position. Refer to the mounting information shown in the illustration after this
paragraph for this model. Mount the touchpanel with #6-32 hardware (not supplied).
Wired Touchpanels
PAN HEAD SCREWS
TOUCHPANEL
COVER
SeriesSeries 1600 Wired Touchpanels • 7

Advertisement

Table of Contents
loading

Table of Contents