Adjustment Tools; Instrument Service Position - HP 8562E Service Manual

For adjustments requiring a nonmetallic tuning tool, use fiber tuning tool, HP part number
Two different tuning tools may be necessary for IF bandpass adjustments, depending upon
the type of tuning slug used in the slug-tuned inductors. If the tuning slug requires a slotted
tuning tool, use HP part number 8710-1010. If the tuning slug requires a forked tuning tool,
use HP part number 8710-0772.
Never try to force an adjustment control. This is especially critical when tuning variable
capacitors or slug-tuned inductors. Required service accessories, with part numbers, are listed
under "Service Kit" in Chapter 1, "General Information."
Refer to Chapter 4, "Assembly Replacement ," for information on removing the spectrum
analyzer cover assembly and accessing all internal assemblies.
Adjustment Procedures 2-3