Pinion Assembly/Clutch Armature/Clamp
Pinion Assembly/Clutch Armature/Clamp
Pinion Assembly/Clutch
Armature Removal
Pinion Assembly
If pinion assembly (29) is not removed from
clutch housing (19), do 1. through 3.
Otherwise, start at 4.
1.
Remove drive housing.
2.
Disconnect clutch cable connectors from
inside of pressure control.
a.
Remove two screws (71) and swing
down cover (70a).
b.
Disconnect engine leads from
board to engine.
c.
Remove strain reliefs 70r and 130.
3.
Remove four screws (36) and pinion
assembly (29).
36
37
4.
Place pinion assembly (29) on bench
with rotor side up.
3A4108F
36
37
29
ti5480a
5.
Remove four screws (28) and lock
washers (24). Install two screws in
threaded holes (E) in rotor. Alternately
tighten screws until rotor comes off.
28
24
E
6.
Remove retaining ring (29b).
7.
Turn pinion assembly over and tap
pinion shaft (29a) out with plastic mallet.
29b
29a
29
E
ti5481a
ti5987b
27
29d
ti5482a
25