Creating A Serial Connection - Bosch VIP-X16XF-E Installation Manual

18 en | Connection
A zero potential closing contact or switch can be used as the actuator. If possible, use a
bounce-free contact system as the actuator.
CAUTION!
Please observe the labeling on the unit.
1.
2.
Relay output
The VIP X16 XF E encoder has one relay output for switching external units such as lamps or
alarm sirens. You can operate the relay output manually while there is an active connection to
the encoder. The output can also be configured to automatically activate sirens or other alarm
units in response to an alarm signal. The relay output is also located on the terminal block.
CAUTION!
Please observe the labeling on the unit.
A maximum load of 30 V
1.
2.
Further topics:
–
5.5

Creating a serial connection

The bidirectional data interface is used to control units connected to the VIP X16 XF E
encoder, such as a dome camera with a motorized lens. The connection supports the RS-232,
RS-422, and RS-485 transmission standards. A video connection is necessary to transmit
transparent data.
F.01U.281.864 | V2 | 2012.12
Connect the lines to the appropriate terminals on the terminal block (IN1 to IN4) and
check that the connections are secure.
Connect each alarm input to a ground contact (GND).
(SELV) and 200 mA may be applied to the relay contacts.
p-p
Connect the lines to the appropriate terminals R on the terminal block and check that the
connections are secure.
Connect the terminal block to the socket on the unit observing the labeling.
Section 7.7 Terminal block, page 24
Installation Manual
VIP X16 XF E
Bosch Sicherheitssysteme GmbH