Creating A Serial Connection - Bosch VIDEOJET multi 4000 Installation Manual

VIDEOJET multi 4000
2.
See also
–
5.5

Creating a serial connection

Notice!
For correct connection, observe the labelling on the unit.
The bidirectional data interface is used to control units connected to the VIDEOJET multi 4000
encoder, such as a dome camera with a motorized lens. The connection supports the RS-232,
RS-422, and RS-485 transmission standards. A video connection is necessary to transmit
transparent data.
The serial interface is also located on the terminal block.
The range of controllable equipment is expanding constantly. The manufacturers of the
relevant equipment provide specific information on installation and control. Please take note
of the appropriate documentation when installing and operating the peripheral to be
controlled. The documentation contains important safety instructions and information about
permitted uses.
1.
2.
See also
–
Bosch Sicherheitssysteme GmbH
Connect the terminal block to the socket on the unit observing the labeling.
Terminal block, page 25
If you require a serial connection to the unit, connect the relevant cables to the terminal
block and check that the connections are secure.
Connect the terminal block to the socket on the unit observing the labeling.
Terminal block, page 25
Installation Manual
Connection | en 19
2014.02 | V1 | F.01U.298.750