Bissell SPOTBOT 2117 User Manual page 9

Using the Automatic Cleaning Cycles
Tips Before Using Your SpotBot®
• Dry vacuum the area first, before spot cleaning with the SpotBot.
• Some spots and spills require that you pick up the chunky debris with a rag or towel
before you begin cleaning in the automatic or manual cycles.
1
Quick Clean This cycle has been
designed for stains that are on the
surface of your carpeting. This cycle will
run for approximately 3 minutes.
3
Hose/Tool By selecting this option you
can clean spots and stains using the hose
and tool on surfaces such as upholstery,
stairs, car interiors, or any other hard-to-
reach area.
5
Done This light will illuminate and you will
hear a series of "beeps" when the cleaning
cycle is complete. Press the STOP button
to turn the machine OFF. The machine will
not beep when turned off.
2
Deep Clean Use on stains that have had
time to set-in. These are typically the
most difficult stain types to remove. This
cycle runs for approximately 6 minutes.
4
Stop By pressing the red stop button,
you will stop the cleaning cycle
completely. To begin cleaning again,
you will need to start over and select a
cleaning cycle.
WARNING
Keep spray away from face. Failure to do so may
result in personal injury.
www.BISSELL.com
9