Craftsman 247.88690 Operator's Manual page 20

auger Control
Refer to the Assembly section for instructions on adjusting the auger
control cable.
skid shoes
Refer to the Assembly section for instructions on adjusting the skid
shoes.
beLt rePLaCement
auger belt
To remove and replace your snow thrower's auger belt, proceed as
follows:
1. To prevent spillage, remove all fuel from tank by running engine
until it stops.
2. Remove the plastic belt cover on the front of the engine by remov-
ing the two self-tapping screws. See Figure 22.
3. Roll the auger belt off the engine pulley. See Figure 23.
4. Carefully pivot the snow thrower up and forward so that it rests on
the auger housing.
5. Remove the frame cover from the underside of the snow thrower
by removing four self-tapping screws which secure it. See Figure
24.
SERVICE AND MAINTENANCE
20
Figure 22
Figure 23
Figure 24