Honda CB250 TWISTER Owner's Manual page 145

CB250 TWISTER
Installation
1. Attach the right and left side collars in their original
locations on the wheel.
2. To install the rear wheel, reverse the removal
procedure.
Take care to prevent the brake caliper from
scratching the wheel during installation.
NOTICE
When installing the brake caliper into position,
carefully fit the brake disc between the pads to
avoid scratching them.
3. Make sure that the slot on the brake caliper bracket
is positioned in the lug on the swingarm.
1. Brake caliper
1 2
bracket
2. Slot
3. Lug
4. Swingarm
4
3
4. Adjust the drive chain (page 47).
5. Install and tighten the rear axle nut.
Torque: 88 N.m (9.0 kgf.m, 65 lbf.ft)
6. Tighten the drive chain adjusting nuts lightly, then
hold the adjusting nuts and tighten the lock nuts.
Torque: 21 N·m (2.1 kgf·m, 15 lbf·ft).
7. After installing the wheel, apply the brake pedal
several times, then check if the wheel rotates freely.
Recheck the wheel if the brake drags or if the wheel
does not rotate freely.
If a torque wrench was not used for installation,
see your dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of
braking capacity.
59