Receiving, Handling And Storage; Acceptance Tests And Equipment Calibration - GE BUS1000 Instructions Manual

Bus bar protection

Table of Contents

6. 6. 6. 6.

The systems are provided to the customer in a special packing unit that properly protects it during

transportation, provided it is done under normal conditions.

Immediately after receiving the equipment, the customer should check if there is any evidence of the system

having suffered damage during transportation. If injury or damage resulting from rough handling is evident,

file a damage claim at once with the Transportation Company and promptly notify the factory.

Reasonable care should be exercised in unpacking the relay in order not to lose the accessories provided in

the box.

If the equipment is not going to be installed immediately, it is convenient to store it in its original packing, in a

place free from moisture and dust.

It is important to check that the inscription on the nameplate matches the data in the order.

6.1.

It is recommended, once the equipment is received, that a visual inspection and the tests given below be

performed to make sure that the relay has not suffered any damage in transportation and the factory

calibration has not been altered.

In the description of each test instructions for the calibration of every measuring unit are included. The units

must only be readjusted if the values measured are beyond the indicated tolerance limits.

The tests described in chapter 12, can be carried out as installation or acceptance tests, depending on the

criteria of the user. Since most users have different procedures for installation and acceptance tests, this

section explains all the tests that can be performed on the systems.

GEK-98514B

RECEIVING, HANDLING AND STORAGE

BUS1000 Busbar Protection

6. RECEIVING, HANDLING AND STORAGE

6-1

Table of Contents