Shindaiwa 358Ts Operator's Manual page 32

OPERATION
3. Move control lever (A) to
"WARM START" position.
4. Securely hold the chain saw as
shown and pull starter handle.
Note: Do not pull starter rope out
to maximum position. Do
not allow recoil handle to
snap back against the
casing.
5. Control lever (A) may be moved
to "COLD START" position if
necessary, but after first starting
sound, squeeze throttle trigger to release choke and return engine to
idle.
6. When engine starts,
immediately squeeze and
release throttle trigger (B) to
disengage throttle latch and
return engine to idle. Pull front
hand guard (C) towards the
operator immediately (chain
brake unlocked position).
Note: If engine does not start
after 5 pulls, use Start
Cold Engine procedure.
Do not increase engine speed while chain brake is locked.
Severe brake damage will result.
32
A
c
© 01/2021 ECHO Incorporated
358TS
B
X7503325400