Specifications - Johnson Controls GS-20 Series Installation Sheets Manual

Specifications

4 G—GS-20/25 and GS-40/45 Series Single-block Multi-function Gas Control Valves Technical Bulletin
Table 2: Specifications
Media 1st (Manufactured Gas), 2nd (Natural Gas), and 3rd (Liquefied
Petroleum [LP] Gas) Family Gases
Maximum Inlet Europe:
Pressure GS-_01 _ and GS-_02_: 360 mbar
GS-251_ and GS-252_: 200 mbar
All Other Models:
North America:
GS-_01 _ and GS-_02_: 5 psi
GS-251_ and GS-252_: 2 psi
All Other Models:
Maximum 20 mbar (8 in. W.C.) (GS-_ 03_)
Regulating 50 mbar (20 in. W.C.) (GS-405_ and GS-406_)
Setting
Reverse 150 mbar (60 in. W.C.) minimum; Class A (EN 161)
Pressure Rating
Regulator Spring Regulator (GS-_03_):
Classification Servo Regulator (GS-405_):
Permissible -15 to 60°C (5 to 140°F)
Ambient
Temperature
Body Detachable flanges with pipe thread 3/8 to 1-1/2 in. NPT or Rp
Connections
Valve Torsion Group 2 (EN 88 and EN 161)
Group
Flanges:
Pressure Taps
Body:
Materials Body and Flanges:
Diaphragms and Seals: Perbunan rubber
Solenoid Enclosure:
Filter Segment Standard Dirt Strainer: 0.5 mm (0.02 in. ) metal mesh
Optional Filter Set:
Operating Time 100% Continuous
Rating
Valve Timings Closing Time:
Opening Time:
Dead Time:
Electrical Standard Wiring:
Connections
Optional Wiring:
Coil Insulation Class F
Class
Agency IAS (AGA/CGA) Certificate Numbers: C0197002
Listings
European Certificate Number:
Specification EN 88, EN 126, and EN 161
Standards Complying with the EMC Directive
Standards
Standards Complying with the Low Voltage Directive
ANSI Standards, Z21.18, Z21.21, and Z21.78
Canadian Standards CAN1-6.3 and CAN1-6.5
The performance specifications are nominal and conform to acceptable industry standards. For
application at conditions beyond these specifications, consult the local Johnson Controls office.
Johnson Controls, Inc. shall not be liable for damage resulting from misapplication or misuse of its
products.
Refer to the GS-20/25 and GS-40/45 Series Product Bulletin (LIT-4350240) for necessary information on
operating and performance specifications of this product.
100 mbar
0.5 psi
Class B (EN 88)
Class A (EN 88)
9.0 mm (0.35 in.) spigot for flexible tubing
Rp 1/8 thread standard (multi-position)
Rp 1/4 thread special (multi-position) GS-4 only
Die cast aluminum
IEC 529 (NEMA 1 and IP 54)
0.05 mm (0.002 in.) nylon mesh and fleece filter
< 1 second
< 1 to 15 seconds
< 1 second
PG 13.5 compression fitting with cage-type
terminal blocks inside the electrical box
1/2 in. NPT conduit adapter or
4-pin connector plug (ISO 4400 [DIN 43650])
C0197004
CE 0063AN3731