Table of Contents
Advertisement
1. If you open the drawer (
2. Insert the supplied hex wrench (
3. Please adjust the height turning the hex wrench (
counter-clockwise (
When you turn the hex wrench counter-clockwise(
4. After adjusting the doors, please insert the supplied fastener-ring (
the gap between the hinge-grommet (
you'll need to insert depends on the gap.
Two fastener-rings are enclosed with the refrigerator.
The thickness of each fastener-ring is 1mm(0.04 inch).
ADJUSTING ThE FREEZER DRAWER lEVEl
Adjustment part
1. Locate the height-adjuster (
Unscrew the four Phillips screws (
2. Loosen the controller screw(
), you can see the lower hinge (
) into the shaft (
).
) and the lower hinge(
) in the freezer drawer.
) slightly to loosen the door.
) with a Phillips screwdriver.
).
) of the lower hinge.
) clockwise(
) or
), the door will move up.
) using a pair of pliers (
). The number of fastener-rings
Freezer Drawer
) in
SettingUp _
Hide quick links:
Advertisement
Table of Contents
