Table Of Contents - Viessmann Vitocrossal 300 Service Instructions Manual

Steps - commissioning, inspection and maintenance
Commissioning steps
Inspection steps
Maintenance steps
•
1. Checking the high limit safety cut-out setting................................................................ 10
•
2. Filling the heating system with water and venting......................................................... 10
• • •
3. Filling the trap with water.................................................................................................. 11
•
4. Fully opening and locking the butterfly valve in the flue outlet (if installed)............... 11
• • •
5. Commissioning the system............................................................................................... 12
•
6. Minimising pulsation noise............................................................................................... 13
• •
7. Shutting down the system................................................................................................. 13
• •
8. Opening the boiler door..................................................................................................... 13
• •
9. Separating the neutralising system from the heat exchanger module and
connecting the drain hose................................................................................................. 14
• •
10. Cleaning the combustion chamber and heating surfaces............................................. 14
• •
11. Checking the boiler door/burner gaskets and thermal insulation sections................. 14
• • •
12. Checking all connections and the sensor well on the heating water side for
tightness............................................................................................................................. 16
• •
13. Checking the function of the safety equipment.............................................................. 18
• • •
14. Checking the pressure switch function........................................................................... 18
• • •
15. Checking the temperature controller setting if a building management system is
used (DCC system)............................................................................................................ 18
• • •
16. Expansion vessel and system pressure.......................................................................... 18
•
17. Cleaning the sight glass in the boiler door...................................................................... 19
• •
18. Closing the boiler door...................................................................................................... 19
•
19. Checking the thermal insulation....................................................................................... 19
• •
20. Checking the water quality................................................................................................ 20
• •
21. Cleaning and reconnecting the condensate drain system............................................. 20
•
22. Checking the installation room vent
• •
23. Adjusting the burner.......................................................................................................... 20
• •
24. Checking the flue gas side tightness............................................................................... 21
•
25. Checking the flue system for leaks
•
26. Instructing the system user.............................................................................................. 21
•
27. Operating and service documents................................................................................... 21
Commissioning, inspection, maintenance
Page
9