Honda DREAM125 2018 Owner's Manual page 89

Tyre Puncture
u
8. Remove the drive chain from the driven
sprocket by pushing the rear wheel forward.
9. Remove the rear axle shaft, drive chain
adjusters, side collars and rear wheel from
the swingarm.
Rear axle shaft
Drive chain
adjuster
Drive chain
Installation
1. To install the rear wheel, reverse the
removal procedure.
2. Tighten the rear axle nut.
Torque: 59 N·m (6.0 kgf·m, 44 lbf·ft)
84
Removing Wheels
Drive chain
adjusting nut
Drive chain
lock nut
3. Tighten the brake stopper arm nut.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft)
4. Adjust the rear brake pedal freeplay.
P. 64
2
5. Adjust the drive chain slack.
6. After installing the wheel, apply the brake
pedal several times, then check if the wheel
rotates freely. Recheck the wheel if the brake
drags or if the wheel does not rotate freely.
7. Install the chain covers.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
A used cotter pin may not effectively secure a
fastener. Always replace a used cotter pin with
a new one.
P. 71
2
P. 70
2