Chevrolet Blazer Owner's Manual page 72

Danger
If using a rear-facing child restraint on
the front passenger seat, the airbag for
the front passenger seat must be off. This
also applies to certain forward-facing
child restraints as indicated in the tables
listed in this manual.
See Passenger Sensing System 0 56.
If the child restraint uses a top tether, see
ISOFIX Child Restraint Systems 0 69 for top
tether anchor locations.
Do not secure a child restraint in a position
without a top tether anchor if a national or
local law requires that the top tether be
anchored, or if the instructions that come
with the child restraint say that the top
tether must be anchored.
When using the lap-shoulder belt to secure
the child restraint in this position, follow the
instructions that came with the child
restraint and the following instructions:
1. Put the child restraint on the seat.
2. Pick up the latch plate, and run the lap
and shoulder portions of the vehicle's
seat belt through or around the child
restraint. The child restraint instructions
will show you how.
Tilt the latch plate to adjust the belt if
needed.
3. Push the latch plate into the buckle until
it clicks.
Position the release button on the
buckle, away from the child restraint, so
that the seat belt could be quickly
unbuckled if necessary.
The push button used to release the
latch plate must be visible and not
obscured by the child restraint. There
must not be direct contact of the child
restraint to the push button.
4. Pull the shoulder belt all the way out of
the retractor to set the lock. When the
retractor lock is set, the belt can be
tightened but not pulled out of the
retractor.
5. Follow the instructions in the child
restraint owner s manual to tighten and
lock the child restraint when using the
vehicle seat belt.
Seats and Restraints
6. Try to pull the belt out of the retractor
to make sure the retractor is locked.
If the retractor is not locked, repeat
Steps 4 and 5.
7. If the child restraint has a top tether,
follow the child restraint manufacturer s
instructions regarding the use of the top
tether. See ISOFIX Child Restraint Systems
0 69.
8. Before placing a child in the child
restraint, make sure it is securely held in
place. Push and pull the child restraint in
different directions to be sure it is
secure.
To remove the child restraint, follow the
instructions in the child restraint owner s
manual to unlock it. Unbuckle the vehicle
seat belt and let it return to the stowed
position. If the top tether is attached to a
top tether anchor, disconnect it.
71