Sony XAV-65 Service Manual page 4

XAV-65
Ver. 1.1
NOTE OF REPLACING THE CHASSIS MAIN ASSY (CHA1)
When the chassis MAIN assy (CHA1) is replaced, the destination
setting is necessary.
Note: Remote commander is necessary.
1. Destination Setting
Set destination according to the procedure below.
1-1. Setting the Destination Code
1. Set the demonstration mode OFF.
(Touch to select "Settings" t "Screen Settings" t "Demo"
on the screen, and set the "OFF".
2. In the state of source off (Home screen is displayed), enter the
destination setting mode by pressing the buttons on the remote
commander in order of the [4] t [5] t [6] (press only the
[6] button for two seconds).
3. The following screen is displayed and the destination setting
mode becomes effective.
(Displayed characters/values in the following fi gure are ex-
ample)
Note: Refer to following "1-2. Entering the Destination Code" for opera-
tion method.
<DESTINATION SETTING MODE>
0 0 0 0 0 1
E U R : 0 0 0 0 0 0
E 1 7 : 0 0 0 0 1 2
R U 2 : 0 0 0 0 0 4
E A : 0 0 0 0 1 A
4. The resetting operation is executed by pressing the [ENTER]
button on the remote commander the setting ends, and the unit
returns to the normal condition.
1-2. Entering the Destination Code
Note: Input of the destination code cannot be performed by the keys of
main unit. Be sure to input the destination code by remote com-
mander.
• Method of operation by remote commander
Note 1: The model to which the remote commander is not attached
can also be operated by using the remote commander.
Note 2: The ten key cannot be used.
4
U C : 0 0 0 0 0 1
E : 0 0 0 0 0 3
I N : 0 0 0 0 1 5
E T 4 : 0 0 0 0 1 C
1. Press the [ V ] or [ v ] button, and select the alphanumeric char-
acter of "0 to F".
2. The digit advances by pressing the [ b ] button.
The digit returns by pressing the [ B ] button.
3. The setting is completed by pressing the [ENTER] button, and
the initialization operation is done.
1-3. Destination Code
Destination
US and Canadian models
AEP and UK models
Russian model
E (NTSC) model
E (PAL) model
Saudi Arabia model
Indian model
Australian model
2. Confi rmation After Destination Setting
Execute the following operation after completing the destination
setting, and confi rm a correct destination was set.
Destination setting checking method:
1. In the state of source off (Home screen is displayed), enter the
test mode by pressing the buttons on the remote commander in
order of the [4] t [5] t [0] (press only the [0] button for two
seconds).
2. The following screen is displayed and confi rm that item of the
destination has been rewritten correctly.
(Displayed characters/values in the following fi gure are ex-
ample)
<Test Mode>
4.VISUAL FACTORY MODE
6.DESTINATION SETTING MODE
DEST: UC
MCU: SONY-ST01-130929
Graphic: SONY-TW01-130929
Mecha: SONY-SP01-130929
Servo: HI6CD1-BBA-893D
3. The resetting operation is executed by pressing the [ENTER]
button on the remote commander the confi rming ends, and the
unit returns to the normal condition.
Destination code
000001
000000
000004
000003
000012
00001A
000015
00001C
REGION: 1