Service Mode; How To Clear User Setting - Panasonic KX-TG3711BXB Service Manual

9 Service Mode

9.1.

How to Clear User Setting

Units are reset to the Factory settings by this operation (Erase stored Phone numbers, Caller list and etc.)
Note:
• Some menus are not reset. Refer to Operating Instructions (P.24).
• The reset menus differ depending on the following operations.
• This operation should not be performed for a usual repair.
9.1.1. Resetting both base unit and handset
Both the base unit and the registered handset which you did the following steps
will not be reset.
1
Connect the AC adaptor to the base unit and install the charged batteries into the handset.
2
Confirm the handset is registered to the base unit (
If the handset is not registered to the base unit (
3
Lift the handset and press {OFF} to put the handset in standby mode.
4
Press 1 , 5 ,
5
Disconnect the AC adaptor, then remove the battery.
Note:
(*1) Refer to Registering a Handset to the Base Unit (P.39).
9.1.2. Resetting only handset
The only handset is reset by doing the following steps
1
Install the charged batteries into the handset.
2
Lift the handset and press {OFF} to put the handset in standby mode.
3
Press 1 , 5 ,
4
Remove the battery.
Note: (*2)
• The handset registration to the base unit is cancelled.
• If the handset needs to be registered to the base unit, refer to Registering a Handset to the Base Unit (P.39).
• If users do not bring the base unit with them, the registration procedure has to be done by users themselves.
w
Handset
9 and key of the handset simultaneously until a confirmation tone is heard.
8 and # key of the handset simultaneously until a confirmation tone is heard. (*2)
Base unit
lights).
flashes), register it. (*1)
1
to .
④
Handset
31
KX-TG3711BX/KX-TG3712BX/KX-TG3719BX/KX-TGA371BX
1
to are reset. Other registered handsets
④