Cobra XRS 9630 Operating Instructions Manual page 10

Settings
Your Detector
Intro Operation Customer Warranty
Assistance
What to Remember While Using IntelliMute
IntelliMute works with all City and Auto Mute modes.
Whenever engine revs are below the activation point, an arrow
in Icons
pointing down will appear in the display. Above the activation point,
Secondary Icons
an arrow pointing up will appear.
Below Activation Point Above Activation Point
in Icons
Intro Operation Customer Warranty
N W i h N W i h
Assistance
Notice
If, for any reason, the unit stops sensing your engine's revs,
Intro Operation IntelliMute will indicate an error and automatically turn off. Customer Warranty
Assistance
condary Icons
The rev point you set will be stored in the unit's memory when
power is turned off and recalled each time the power is turned on.
condary Icons NOTE
The rev point must be reset if you use your detector in a different vehicle.
Notice
NOTE
When initially choosing your IntelliMute activation point, a setting
Notice
Operation Customer of approximately 300 to 600 RPMs above idle is recommended. Warranty
Assistance
You can reset the activation point at any time to fit your individual
preferences and driving style.
Customer
Installation
Setting the IntelliMute Activation Point
Assistance
Your detector must be installed in your vehicle.
CAUTION
Do not attempt to set the rev point while driving.
Notice Caution Warning
Your vehicle should be parked and idling.
IntelliMute must be turned on before setting the activation point.
14 English
Settings
Your Detector
Intro Operation Customer Warranty
Assistance
Select/Dim Button
Program/Mute Button
Secondary Icons
To Set the IntelliMute Activation Point Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to Set
Tone
IntelliMute.
None
Notice
Press and release the Set/City button Two beeps
to begin setting IntelliMute RPMs.
Rev your engine to the level you wish to None
set. Rev the engine slightly above idle and
hold revs steady for two seconds.
At the desired rev level, press and Three beeps
release the Set/City button.
Press and release either the None
Main Icons
Select/Dim button to proceed to the
next user mode or the Program/Mute
button to exit the Program mode.
Setting IntelliMute RPMs
Intro Operation Customer Warranty
Assistance
Set Intel... Press SET... Intelli
Mute
Secondary Icons
Set!
NOTE
If the unit is unable to sense usable pulses within three seconds or if you do not
Notice
set a rev point within 20 seconds of beginning these steps, IntelliMute will
indicate an error and automatically turn off.
Tone Visual Display
One beep IntelliMute not set
Please try again
One beep IntelliMute Off
Set/City
Button
Visual Display
Set IntelliMute
Press SET at
desired RPMs...
None
IntelliMute Set!
None
IntelliMute Off
IntelliMute
Not Set
Intelli
IntelliMu...
Mute
Please tr...
Off
Nothing Comes Close to a Cobra ® 15