Cobra microTALK LI7200-2WXVP Owner's Manual page 8

10293_LI7200WX_vB.qxd 9/5/07
Main Icons
Main Icons
Mode Functions
Operation
Intro Operation Customer Warranty
Intro Operation Customer Warranty
Assistance
Set DCS Privacy Codes
Assistance
To select a DCS privacy code:
Mode Button
1. After selecting a channel, press the Mode
button until the DCS icon appears and the
Secondary Icons
small numbers flash on the display
(01 through 104).
Secondary Icons
DCS Privacy Code
NOTE
If CTCSS is turned on at the channel
selected, the display will flash the
Notice
DCS icon and "OFF." To switch from
CTCSS to DCS, press the Channel Up
Channel Buttons
Notice
or Channel Down button while the
display is flashing "OFF." The display
will then show the small numbers
flashing and you will then be able
to proceed to step 2.
2. Press the Channel Up or Channel Down
button to select a DCS privacy code. You can
hold the Channel Up or Channel Down button
for fast advance.
3. When your desired DCS privacy code is
displayed, choose one of the following:
a. Press the Mode button to enter the new
setting and proceed to other functions.
b. Press the Lock/Enter button to enter the
new setting and return to Standby mode.
c. Do not press any buttons for 15 seconds
to enter the new setting and return to
Standby mode.
10
10:55 AM Page 10
Main Icons
Introduction
NOAA* All Hazards Radio Channels
•
You can use your microTALK
Radio channels transmitting in your area.
Mode Button
Secondary Icons
Hazards Radio Icon
Channel Buttons
Operation Customer Assistance Warranty
Intro Operation Customer Warranty
Assistance
•
® radio to listen to NOAA All Hazards
To listen to All Hazards Radio channels:
1. Press the Mode button until the WX (All
Hazards Radio) icon, the currently selected All
Hazards Radio channel, and signal strength
are displayed.
2. Use the Channel Up or Channel Down button
to change All Hazards Radio channels.
3. WX (All Hazards Radio) icon will continue to
be displayed when All Hazards Radio is on.
Notice
Choose one of the following:
a. Press the Mode button to proceed
to other functions.
b. Press the Lock/Enter button to exit All
Hazards Radio channels mode and return
to Standby mode.
*National Oceanographic and Atmospheric Adminstration
11