Cobra microTALK LI7200-2WXVP Owner's Manual page 14

10293_LI7200WX_vB.qxd 9/5/07
Main Icons
Mode Functions
Operation
Intro Operation Customer Warranty
During memory location scan (while receiving an Incoming
Assistance
transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that
memory location.
b. Your radio will remain on that memory location and return to
Standby mode. Press the Channel Up or Channel Down button
Secondary Icons
to resume scanning memory locations.
c. After 10 seconds of inactivity, unit starts scan again.
If you press the Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on
the memory location on which, during scanning, you last received
Notice
a transmission.
If you do not press any button within 10 seconds, your radio
will automatically resume scanning memory locations.
During memory location scan (while not receiving a
transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on the
channel/privacy code that was displayed before you entered
mode functions or memory location on which, during
scanning, you last received a transmission.
b. Press the Mode button to proceed to other functions.
c. Press the Lock/Enter button to return to Standby mode
on the channel/privacy code that was displayed before you
entered mode functions or the memory location on which,
during scanning, you last received a transmission.
To reduce the number of memory locations being scanned,
you may de-program any unwanted locations. (See page 16
to de-program a memory location.)
22
10:55 AM Page 22
Main Icons
Introduction
VibrAlert ® and Call Alert
Your microTALK
sounding an audible call tone, by vibrating silently or both.
Mode Button
Secondary Icons
Channel Buttons
Operation Customer Assistance Warranty
Intro Operation Customer Warranty
Assistance
® radio can alert you to incoming signals by
To change call settings:
VibrAlert ® + Ring
1. Press the Mode button
until the Call Setting icon
flashes on the display.
The current setting ("01"
vibrate + ring, "02" vibrate VibrAlert ® Only
only or "03" ring only)
is displayed.
2. Press the Channel Up or
Notice
Channel Down button to
Ring Only
change the call setting.
3. Choose one of the following:
a. Press the Mode button
to enter the new setting
and proceed to other functions.
b. Press the Lock/Enter button to enter the
new setting and return to Standby mode.
23
•