Call Button - Cobra microTALK CXT425 Owner's Manual

Using Your Radio
Operation
Channels
Channel Buttons
With the radio on, select any of the 22 channels
by pressing the Channel Up or Channel Down
button.
Both radios must be tuned to the
Channel Number
same channel to communicate.
Channels 1 through 7 are shared by FRS and
GMRS. Channels 8 through 14 are FRS only.
Channels 15 through 22 are GMRS only.
See page 21 for FRS/GMRS frequency
allocations and compatibility charts.
Listening Listening for a Response
Release the Talk button to receive incoming
transmissions. Your microTALK radio is always in
Standby mode while the Talk or Call buttons are
not pressed.
Volume Knob
Volume
Rotate the On/Off Volume knob.

Call Button

To alert another person that you are calling:
Call Button
Press and release the Call button.
The other person will hear a two second
call tone. This tone is used only to establish voice
communications.
See page 19 on how to select from
10 available call tone settings.
4
Introduction
Enter/Hi-Low Button
•
Hi Power Icon
Low Power Icon
•
Light/Max Range
•
•
Auto Squelch/Maximum Range
Your microTALK radio is equipped with Auto Squelch, which
automatically shuts off weak transmissions and unwanted noise
due to terrain and conditions. This slightly reduces the Maximum
Range at which signals can be heard.
You can turn off auto squelch to allow all signals to be received
and extend the maximum range of your radio.
Operation Customer Assistance Warranty
Selectable High•Low Power Output
When in close proximity to another party or during
favorable conditions, you can switch
from High to Low Power to extend battery life.
This feature applies to GMRS Channels
1 through 7 and 15 through 22 only.
Channels 8 through 14 operate
exclusively on low power.
To toggle between high and low power:
Press the Enter/Hi•Low button for
two seconds.
When using Channels 1 through 7 and
15 through 22 on high power, the Hi icon
will be visible on the display.
When using those channels on low power
and on Channels 8 through 14, the Low icon
will be visible on the display.
To Illuminate Display
Press and release the Light/Max Range button
to illuminate the display for 10 seconds.
•
•
•
5