Cobra microTALK CXT425 Owner's Manual page 8

Mode Functions
Operation
Set DCS Privacy Codes
To select a DCS privacy code:
Mode/Lock Button
1. After selecting a channel, press the Mode/Lock
button until the DCS icon appears and the small
numbers flash on the display
(01 through 83).
DCS Privacy Code
If CTCSS is turned on at the channel
selected, the display will flash the DCS
icon and "OFF." To switch from CTCSS to
DCS, press the Channel Up or Channel
Channel Buttons Down button while the display is flashing
"OFF." The display will then show the
small numbers flashing and you will then
be able to proceed to step 2.
2. Press using the Channel Up or Channel Down
button to select a DCS privacy code. You can
hold the Up or Down button for fast advance.
3. When your desired DCS privacy code is
displayed, choose one of the following:
a. Press the Mode/Lock button to enter the new
setting and proceed to other functions.
b. Press the Enter/Hi•Low button to enter the
new setting and return to Standby mode.
c. Do not press any buttons for 15 seconds
to enter the new setting and return to
Standby mode.
NOAA* All Hazards Radio Channels
You can use your microTALK radio to listen to NOAA All Hazards Radio
channels transmitting in your area.
To listen to All Hazards Radio channels:
Mode/Lock Button
1. Press the Mode/Lock button until the
All Hazards Radio icon, the currently
selected All Hazards Radio channel,
and signal strength are displayed.
2. Use the Channel Up or Channel Down
button to change All Hazards Radio channels.
10
Introduction
•
Hazards Radio Icon
Channel Buttons
Enter/Hi-Low Button
Voice Activated Transmit (VOX)
In VOX mode, your microTALK radio can be used "hands-free,"
automatically transmitting when you speak. You can set the VOX
sensitivity level to fit the volume of your voice and avoid transmissions
triggered by background noise.
Mode/Lock Button
VOX Icon
Channel Buttons
•
Operation Customer Assistance Warranty
3. The All Hazards Radio icon will continue to
be displayed when All Hazards Radio is on.
Choose one of the following:
a. Press the Mode/Lock button to proceed
to other functions.
b. Press the Enter/Hi-Low button to exit
All Hazards Radio channel mode and
return to Standby mode.
c. Press Talk button to exit and start on
last used transmitting channel.
*National Oceanographic and Atmospheric Administration
To turn VOX mode on or off:
1. Press the Mode/Lock button until the VOX icon
flashes on the display. The current on
or off setting is displayed.
2. Press the Channel Up or Channel Down button
to turn VOX on or off.
3. Choose one of the following:
a. Press the Mode/Lock button to enter the
selected on or off setting and proceed to
other functions.
b. Press the Enter/Hi•Low button to enter
the selected on or off setting and return
to Standby mode.
To set VOX sensitivity:
1. Press the Mode/Lock button until the VOX icon
flashes and the current sensitivity level
is displayed.
•
11