Honda CMX500A 2019 Owner's Manual page 79

Remove the oil filter with a filter wrench
6.
and let the remaining oil drain out. Make
sure the prior seal is not stuck to the
engine.
Discard the oil and oil filter at an
u
approved recycling centre.
Apply a thin coat of engine oil to the
7.
rubber seal of a new oil filter.
8.
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft)
9.
Torque: 30 N·m (3.1 kgf·m, 22 lbf·ft)
10.
Oil filter
Required oil
Rubber seal
11.
12.
Engine Oil Changing Engine Oil & Filter
u
Install the new oil filter and tighten.
Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
Fill the crankcase with the recommended
oil ( P. 57, P. 127) and install the oil fill
2 2
cap.
When changing oil & engine oil
filter:
2.7 L (2.9 US qt, 2.4 Imp qt)
When changing oil only:
2.5 L (2.6 US qt, 2.2 Imp qt)
Check the oil level.
2
Check that there are no oil leaks.
P. 72
75