Output Controls; In/Out Meters And Output Control; Reversing The Signal Polarity - Shure DFR11EQ User Manual

OUTPUT CONTROLS

IN/OUT Level Meters and Output Control
The IN and OUT level meters located next to the response curve graph display the levels of the
input and output in dB. When the levels go into the red, the unit is clipping. This is a useful tool for
observing gain loss due to equalization settings. To compensate, you can use the OUTPUT slider
located near the output controls. Raising or lowering this slider will raise or lower the gain of the
output. As the output level is adjusted, the Response Curve Viewer will adjust accordingly, moving
the current response curve to the new level on the graph. If you take a snapshot before adjusting the
output level, the snapshot will remain at the original output level.
To adjust the output gain, drag drop the OUTPUT slider. Or, select the output slider by clicking on
it, then click on the
To activate the IN/OUT level meters:
1. Click on Options in the main menu bar.
2. Click on Display Level Meters option. A check will appear next to this option to indicate
that it is active.
NOTE: While the IN/OUT level meters are running, the NEW indicator on the
DFR11EQ unit will continually flicker. This is normal operation while the IN/OUT
meters are active.
Reversing the Output Signal Polarity
This option is designed for sound systems where there is a component which inverts the polarity
of the signal, bringing it out of phase with the rest of the equipment. Inverted polarity can cause phase
cancellations in the audio. Using this option of the DFR11EQ Version 4 software, you can digitally
invert the audio signal in order to compensate. This will save the time and expense spent in wiring
customized cables. When the polarity is reversed, a red
To use the DFR11EQ with software Version 4 as an audio signal polarity inverter:
1. Click on Options in the main menu bar.
2. Click on Reverse Output Polarity . A check will appear next to this option to indicate that
it is active.
and buttons next to the GAIN field to raise and lower the levels.
appears over the OUT Meter.
28
Main Menu