Table of Contents
Advertisement
Operation
EMU32722
Procedure for tilting up (power tilt
models)
1.
Place the remote control lever / gear
shift lever in neutral.
2.
Press the power tilt switch "
the outboard motor has tilted up com-
pletely.
3.
Push the tilt support knob into the clamp
bracket to support the engine.
42
EWM00261
After tilting the outboard motor, be sure
to support it with the tilt support knob or
tilt support lever. Otherwise the outboard
" (up) until
motor could fall back down suddenly if oil
in the power trim and tilt unit or in the
power tilt unit loses pressure.
ECM01640
CAUTION:
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be trail-
ered in the normal running position, use
an additional support device to secure it
in the tilt position. For more detailed in-
formation, see page 50.
4.
UP
ECM00250
CAUTION:
Be sure to retract the trim rods complete-
ZMU05580
ly during mooring. This protects the rods
from marine growth and corrosion which
could damage the power trim and tilt
mechanism.
WARNING
Models equipped with trim rods: Once
the outboard motor is supported with the
tilt support lever, press the power tilt
switch "
" (down) to retract the trim
rods.
ZMU04884
Advertisement
Table of Contents
