Dell G3 15 3500 Service Manual page 65

Table 12. System setup options—Power Management menu (continued)
Power Management
Battery Charge Configuration
Enable Advanced Battery Charge
Configuration
Block Sleep
Enable USB Wake Support
Enable Intel Speed Shift Technology
Lid Switch
Table 13. System setup options—Wireless menu
Wireless
Wireless Switch
WLAN
Bluetooth
Wireless Device Enable
WLAN
Bluetooth
Table 14. System setup options—POST Behavior menu
POST Behavior
Numlock Enable
Enable Adapter Warnings
Default: Disabled. The system will not automatically power up.
Enables the computer to run on battery during power usage hours. Use the
below options to prevent AC power usage between certain times of each day.
Default: Adaptive. Battery settings are adaptively optimized based on your
typical battery usage pattern.
Enables Advanced Battery Charge Configuration from the beginning of the
day to a specified work period. Advanced Battery Charged maximizes battery
health while still supporting heavy use during the work day.
Default: OFF.
Blocks the computer from entering Sleep (S3) mode in the operating system.
Default: OFF.
NOTE: If enabled, the computer will not go to sleep, Intel Rapid Start will
be disabled automatically, and the operating system power option will be
blank if it was set to Sleep.
Enables the USB devices to wake the computer from Standby mode.
Default: OFF.
Enables or disables Intel Speed Shift Technology support which enables
the operating system to select the appropriate processor performance
automatically.
Default: ON.
Enables the computer to power up from the off state whenever the lid is
opened.
Default: ON.
Determines which wireless devices can be controlled by the Wireless Switch.
For Windows 8 systems, this is controlled by an operating system drive directly.
As a result, the setting does not affect the Wireless Switch behavior.
NOTE: When both WLAN and WiGig are present, enable/disable controls
are tied together. Thus, they cannot be enabled or disabled independently.
Default: ON.
Default: ON.
Enable or disable internal WLAN/Bluetooth devices.
Default: ON.
Default: ON.
Enables or disables Numlock when the computer boots.
Default: ON.
Enables the computer to display adapter warning messages during boot.
System setup 65