For your safety Some DOs and DONTs for you IF IN DOUBT PLEASE CONSULT A COMPETENT ELECTRICIAN. DONT DONT...
Page 4
DONT DONT DONT DONT DONT DONT DONT ** Cold cathode fluoresant lamp in LCD PANEL contains a small amount of mercury, please follow local ordinates or regulations for disposal. Warning: This is a Class product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
WARNING Fingers may be trapped under the TV causing injuries. Hold the TV at the bottom in the middle, and do not allow it to tilt up or down. The TV may fall causing injuries. Hold the bottom of the stand with your hand and tilt the TV up and down.
Getting Started Step 1: Checking the accessories supplied Step 2: Inserting batteries NOTE: Remove the batteries from remote control when it is not to be used for a long period.Otherwise it can be damaged due to any leakage of battery. Old batteries must be disposed in a designated area.
Page 13
ph qÃpxr r vhy Step 4: Connecting an aerial VCR and mains rpÃurÃhr vhy (5, / 68Ãhqh r Ã98ÃDI...
Page 14
rpÃhÃvqrÃqrvpr (5, / ;7 ;7 68Ãhqhr Ã98ÃDI 9&5 Step 5: Using the cable holder...
Page 15
Step 6: Switching the TV ON/OFF SÃGvÃ@ÃTh ÃhhvpÃrh pu ÃD HINT: Depending on the reception conditions in your par- ticular area, you may find that the list of channels found includes one or more repeated names. This is because the receiver may detect and store some channels, including those it cannot receive clearly, from adjacent areas along- side the strong channels from a transmitter nearby.
Basic Operations You can operate your TV both using the remote control buttons. Operation with the buttons on the Operation with Remote Control...
Page 18
EVERYDAY OPERATION Hint: The channel list numbers are assigned by the broadcasters. Because not all channels are broadcast free-to-air and stored by the receiver, the channel list numbers do not run continuously. The fifteenth channel in the list, for example, may not be channel number 15 but channel number 17.
Page 22
WARNING : Do not turn off the main power. The timer function will not work with the main power switched off. When recording on a T-V LINK compatible VCR: When recording on a T-V LINK incompatible VCR:...
Page 23
Cancelling the timer setting Reactivating the cancelled timer setting Configuration...
rÃà rÃÃhÃÃqryrrÃhyyÃpuhryà hqÃrvtÃs Ãsv ÃvrÃvhyyhv4 `r I Common Interface Hint The bar graphs of signal quality and signal level give a good indication of whether any channels are likely to be found. If only the signal level graph shows a high value then it is likely that an analogue channel occu- pies that broadcast frequency.
Setting The TV Menu System MAIN MENU Picture Menu...
Page 29
Note 1: At low signal level, the changings on the Noise Reduction function are not effective when there is menu on the screen. If the menu is removed, the effect of this function is seen. At normal broadcasting, Noise Reduction changings are effective at once.
Program Menu Caution: Using Delete or Insert function rewrite the current channel list in the Program menu. Therefore, the programme numbers of some of channels will change.
Other Features TV Status Sound Indicator Source Menu WHUHR hyÃD hyÃDD Hyper Sound T pr ) UW 9DBDU 6G @YU @YU! @YU! T @YU" Mute Indicator @YU# @YU# T...
No-Signal and Out Of Range Detection (PC mode) Analogue Teletext Source Menu T pr ) Q8 9DBDU 6G @YU @YU! @YU! T @YU" @YU# To operate Teletext @YU# T Sound in PC mode PQÃH@IV...
To select a page of Teletext To Stop Automatic Page Change To Select a Subcode Page To Select Index Page Searching for a teletext page while watching TV To Select Double Height Text To exit Teletext Fastext and Toptext To Reveal concealed Information...
TV and Video Recoder (VCR) Via the RCA jacks NTSC Playback Via the ANT (aerial) socket Camera and Camcorder Decoder Connect the decoder to the video recorder Connecting Headphones...
PC Picture Tips Can not turn the TV on? Sound Can not turn the TV off? Care of the Screen Remote Control Colours of image on screen are abnormal No solution Bad picture (in digital mode) No Image on Display Screen...
Specifications Model Item LT-17D50BK Broadcasting Systems PAL BG, DK, I Channels and Digital : 474 MHz - 858 MHz Frequencies Analogue : 46.25 MHz - 862.25 MHz Cable TV (S1-S20/ S21-S41) Input Signal Video: Analog 0,7 Vp-p 75 ohm positive Sync: TTL Level positive or negative, Seperate sync.
Page 49
Specifications Model Item LT-23D50BK Broadcasting Systems PAL BG, DK, I Channels and Digital : 474 MHz - 858 MHz Frequencies Analogue : 46.25 MHz - 862.25 MHz Cable TV (S1-S20/ S21-S41) Input Signal Video: Analog 0,7 Vp-p 75 ohm positive Sync: TTL Level positive or negative, Seperate sync.
Page 50
Corrections Factory settings: The following corrections are made on the related pages. To reset the TV, highlight the Factory Set- tings line in the menu and press OK. A warning screen is displayed in case of acci- Page 25: dental operation. You can either perform a First Time Installa- tion, effectively resetting the receiver to its rÃÃ rÃÃhÃÃqryrrÃurÃQSÃyvÃ...