Whirlpool | User Manual
•
When in the installed position the mains
plug must be accessible for disconnection.
•
Do not use manual stabilizer
Electric Shock Hazard
electrically earth this appliance.
Do not use an extension cord or a portable
electrical outlet device.
Failure to follow these instructions can
result in death, fire or electric shock.
EARtHING INStRuCtIoNS
This washer must be earthed. In the event
of a malfunction or breakdown, earthing will
reduce the risk of electric shock by providing
a path of least resistance for electric current.
This washer is equipped with a separate earth
wire. The earth wire must be connected into
an appropriate outlet that is properly installed
and earthed in accordance with all local codes
and ordinances.
IMPORTANT : Improper connection of the
equipment-earthing conductor can result in a
risk of electric shock.
Whirlpool Corporation declines any respon-
sibility for damage caused by failure to
observe this rule.
Check with a qualified electrician or serviceman
if you are in doubt as to whether the appliance
is properly earthed.
Do not modify the plug provided with the
appliance – if it does not fit the outlet, have
a proper outlet installed by a qualified
electrician.
WAtER SuppLy REquIREMENtS
•
Cold water tap with 3/4" BSP threads not
more than 1 m from the rear side of the
Washer and at a height of at least 1.3 m
from the foot level.
•
If connected to hot water supply, ensure
that the temperature does not exceed
o
70
C. It may cause a fault or damage to the
machine.
•
The water storage tank should correspond
to a level of 2 to 80 m above the level of tap
and water pressure from 0.2 to 8 kgf/cm
6
•
In case of
inadequate
water pressure,
customer has
to correct the
water supply to
improve flow rate
or pour water
manually.
•
Suggestion to
improve water flow rate:
•
Tank height from water inlet tap should
be greater than 10 ft (refer Picture)
•
ensure that there is no blockage in water
line.
FLooR REquIREMENtS
•
Installing on a carpet is not recommended.
•
Floor must support the washer's total weight
(with water and cloth load) of 143 kg.
•
the floor should have a floor drain or a hole
(according to plumbing laws), where the
washer is installed. This will ensure draining
away any water which may overflow from
the washer due to malfunction or hose leak.
•
Do not place the machine on a slanting,
uneven or unstable surface.
•
Place the machine on a solid leveled surface
to avoid excessive vibration and noise
during operation.
Installation procedure
Before you start:
•
Parts removed during installation like
screws, inlet valve plug, etc. must be
disposed properly.
•
It is necessary to remove all shipping
materials for proper operation and to avoid
excessive noise from the washer.
2