Dip Switch Setting - Citizen iDP-3210 User Manual

(22) Generating specified Pulse (ESC p
Code : [1B]h + [70]h + m + n + n2
* {m = connector pin No. (See table below.)}
{0 n1 FF}
{0 n2 FF}
Signals specified by n1, n2 are output to Connector Pin m.
Bit m (m0) means the followings.
m0
0
1
ON time is considered as n1 x 2ms and OFF time as n2 x 2ms.
When m is out of the defined range, n1, n2 are discarded, where no signals are output.
Drive duty of Drawer is shown below:
ON Time
On Time + OFF Time
(Take OFF time as being 4 times or more longer than ON time.)
(23) Selecting Character Code Table (ESC
Code : [1B]h + [74]h + n
* {0 n 1}
Selecting Page n on the character code table:
"n" means the followings.
n (Hex)
0
1
The initial value of n is specified by dip switch setting. (DS1 -5.6.7)
(Other than Japanese character is specified, IBM #2 is specified.)
m n1 n2)
Data is described in Hex code.
Condition
Drawer kick No. 2 pin
Drawer kick No. 5 pin
^ 
t n)
Data is described in Hex code.
Condition
IBM Character #2
Japanese Character
43
iDP3210 User's Manual
CITIZEN