Serial Interface - Citizen iDP-3210 User Manual

(24) Transmitting the printer status
Code : [1B]h + [76]h
Current printer status is transmitted.
Status sent out consists of 1 byte whose content is as in the table below.
In DTR/DSR control, after receptible state of the host (DSR signal being in SPACE state) is confirmed,
only 1 byte is transmitted. In XON/XOFF control, DSR signal state not being confirmed, only 1 byte is
transmitted.
In DTR/DSR control, when the host is in unreceptible state(DSR signal being in MARK state), it waits
until receptible state is created.
Bit
0
1
2
3
4
5
6
7
Remarks : This command is valid only for serial interface model.
(ESC v)
Function
Not defined
Not defined
Paper end
Not defined
Not used
Not defined
Not defined
Not defined
VALUE
0
With paper Without paper
Fixed to 0
44
iDP3210 User's Manual
1
–
CITIZEN