Port Configuration Detail - Cisco SRW208 User Manual

Chapter 5
Speed
The connection speed of the port is displayed here.
The speed can be configured only when auto-negotiation
is disabled on that port.
Port Management > Port Settings
Duplex
This is the port duplex mode, Full (transmission
occurs in both directions simultaneously) or Half
(transmission occurs in only one direction at a time). This
mode can be configured only when auto-negotiation is
disabled and port speed is set to 10Mbps or 100Mbps.
It cannot be configured on Link Aggregation Groups
(LAGs).
MDI/MIDX
This is the MDI/MDIX status of the port. The
MDI setting is used if the port is connected to an end
station. The MDIX setting is used if the port is connected
to a hub or another switch.
Flow Control
This is the flow control status of the port. It
is active when the port uses Full Duplex Mode.
LAG This indicates if the port is part of a LAG.
Type Displays the port type.
PVE When a port is a Private VLAN Edge (PVE) port,
it bypasses the Forwarding Database and forwards all
unicast, multicast, and broadcast traffic to an uplink.
Uplinks can be ports or LAGs.
Detail The Detail button will open the Port Configuration
Detail screen.
8-Port 10/100 Ethernet Switch with Webview
Advanced Configuration

Port Configuration Detail

Port Management > Port Configuration
Port
The number of the port.
Description
Displays a brief description of the port (can
be entered by clicking on the Detail button).
Port Type
This is the port type.
Admin Status
The port can be taken offline by selecting
the Down option. When Up is selected, the port can be
accessed normally.
Current Port Status
The current status of the port is
displayed here.
Reactivate Suspended Port
port that has been suspended, click the checkbox.
Operational Status This indicates whether or not the
port is active.
Admin Speed
Change the speed of the port here.
Current Port Speed
The current speed of the port is
displayed here.
Admin Duplex Change the duplex mode here.
Current Duplex Mode This is the duplex mode of the
port.
Auto Negotiation
You can enable or disable the port's
Auto Negotiation feature. If using an SFP module, Auto
Negotiation for the specific port should be set to Disable.
Current Auto Negotiation
the port's Auto Negotiation feature.
Admin Advertisement
Specifies the capabilities to be
advertised by the port. Multiple options may be selected
or Max Capability can be selected to cover all of the
options. The available options are:
If you want to reactivate a
This is the current setting of
21