Cisco SRW208 User Manual page 17

Chapter 4
Versions
The Versions screen displays the Boot Version, Software
Version, Loader Version and the Hardware Version.
Versions
Boot Version This file runs when the Switch is turned on.
It performs power-on diagnostics and loads the operating
system for the Switch.
Software Version
This file contains the programming
code that runs the Switch.
Hardware Version The current hardware setup of the
Switch.
General System Information
The General System Information screen displays the System
Description, System Up Time, System Mac Address, System
Contact, System Name and System Location.
Select Edit and press the Enter key to make changes. When
your changes are complete, press the Esc key to return to
the Action menu. Select Save and press the Enter key to
save your changes. To exit, select Quit and press the Enter
key.
General Information
8-Port 10/100 Ethernet Switch with Webview
Configuration Using the Console Interface
Management Settings
From the Management Settings screen, you can set Serial
Port Session Configuration, Telnet Session Configuration,
or Secure Telnet (SSH) Configuration.
Management Settings
Serial Port Configuration
On the Serial Port Configuration screen, the Switch's baud
rate is displayed.
Select Edit and press the Enter key to make changes.
Toggle to the desired speed and when your changes are
complete, press the Esc key to return to the Action menu.
Select Save and press the Enter key to save your changes.
To exit, select Quit and press the Enter key.
Serial Port Configuration
Telnet Configuration
On the Telnet Configuration screen, the time-out is
displayed. The value is entered in seconds. If you do not
want the Telnet session to timeout, you may enter a value
of 0 sec.
Select Edit and press the Enter key to make changes.
When your changes are complete, press the Esc key to
return to the Action menu. Select Save and press the
Enter key to save your changes. To exit, select Quit and
press the Enter key.
11