© 2008-2009 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Dual images for resilient firmware upgrades
●
Up to 12.8-Gbps nonblocking, store-and-forward switching capacity
●
Simplified quality of service (QoS) management using 802.1p, Differentiated Services
●
(DiffServ), or type of service (ToS) traffic prioritization specifications
Power redundancy when used with the Cisco RPS1000 380W Redundant Power Supply
●
Unit
Fully resilient stacking provides optimized growth with simplified management
●
ACLs for granular security and QoS implementation
●
Can be configured and monitored from a standard web browser
●
Secure remote management of the switch via Secure Shell (SSH) and Secure Sockets
●
Layer (SSL) encryption
802.1Q-based VLANs enable segmentation of networks for improved performance and
●
security
Private VLAN Edge (PVE) for simplified network isolation of guest connections or
●
autonomous networks
Automatic configuration of VLANs across multiple switches through Generic VLAN
●
Registration Protocol (GVRP) and Generic Attribute Registration Protocol (GARP)
User/network port-level security via 802.1X authentication and MAC-based filtering
●
Increased bandwidth and added link redundancy with link aggregation
●
Enhanced rate-limiting capabilities, including back pressure, multicast, and broadcast flood
●
control
Port mirroring for noninvasive monitoring of switch traffic
●
Mini jumbo frame support (1600 bytes)
●
Simple Network Management Protocol (SNMP) v1, v2c, v3 and Remote Monitoring (RMON)
●
support
Fully rack-mountable using the included rack-mounting hardware
●
Simple, one-step automated installation and initial configuration
●
Specifications
Table 1 contains the specifications, package contents, and minimum requirements for the Cisco
SFE2000P 24-Port 10/100 Ethernet Switch.
Table 1.
Specifications for the Cisco SFE2000 24-Port 10/100 Ethernet Switch
Specifications
Ports
Buttons
Cabling type
LEDs
● 24 RJ-45 connectors for 10BASE-T/100BASE-TX
● Four 10BASE-T/100BASE-TX/1000BASE-T with 2 Gigabit combo ports
● Shared between mini Gigabit Interface Converter (mini-GBIC) ports
● Console port
● Auto medium dependent interface (MDI) and MDI crossover (MDI-X)
● Auto negotiate/manual setting
● RPS port for connecting to redundant power supply unit
Reset button
Unshielded twisted pair (UTP) Category 5 or better for 10BASE-T/100BASE-TX, UTP
Category 5 Ethernet or better for 1000BASE-T
PWR, Fan, Link/Act, Speed, RPS, Master, Stack ID 1 through 8
Data Sheet
Page 2 of 5