Syntax Of At+ Commands; Help On At Commands; Most Common At-Commands; At? Command Help - Nokia PremiCell Manual

List of at commands

Table of Contents

1.2 Syntax of AT+ Commands

When you want to set or display a value for a setting, or you want to

know the valid values, type in AT+ the command string followed by

"=n", "?", or "=?", and press <ENTER>.

1) AT+__=n To write in a new setting with the command.

2) AT+__? Displays the current setting for the command.

3) AT+__=? Displays all setting values that can be used with the com-

mand.

To get general Help on the AT commands supported by the terminal,

use the commands AT? or AT?0. To get Help on a functional group

of AT

commands type: AT?n (n= the number of the group). You issue AT

commands to the data adapter via your communications applica-

tion. When the data adapter receives a command, it responds with

a message that is displayed on your computer screen.

This section introduces the most commonly used AT commands with

a brief description. You can find more detailed information on the

command on the page indicated in the description.

AT? Command Help (Page 30)

Displays a list of available AT commands and Help in English. This

command must stand alone on the command line.

ATA Answer Command (Page 7)

Answers an incoming call. If there is already a voice call active, the

call is switched to data/fax receiving mode (depending on the ap-

plication you are using).

ATD Dial Command (Page 7)

Initiates a call. When a data call is initiated, the command has to

contain the recipient's number or a directory entry which contains

the stored number.

Table of Contents