Atv Define Response Format; Atx Response Range Selection; At&C Define Dcd Usage; At&D Define Dtr Usage - Nokia PremiCell Manual

ATV Define Response Format

This command determines whether result codes are transmitted in
a numeric form or an alphabetic (or verbose) form.
Syntax:
ATV[0]
ATV1

ATX Response Range Selection

This command selectively enables or disables the response codes
sent to the DTE.
Syntax:
ATX[0]
ATX1
ATX2
ATX3
ATX4
ATX5
AT&C Define DCD Usage
This command determines how the state of the DCD V.24 signal re-
lates to the detection on the received line signal from the distant
enSyntax:
AT&C[0]
AT&C1
*This is "always ON" with 09i/18i PremiCell. The command is includ-
ed for compatibility purposes.
AT&D Define DTR Usage
This command defines how the DTR V.24 signal from the DTE is han-
dled. Syntax:
AT&D[0]
ã2000 Nokia Mobile Phones. All Rights Reserved.
Select numeric (short form) responses.
Select textual (long) responses.
Enable response codes 0... 4.
Enable response codes 0... 5, 10.
Enable response codes 0... 5, 10.
Enable response codes 0... 5, 7, 10.
Enable response codes 0... 5, 7, 8, 10.
Enable all response codes.
Keep DCD always ON.
Enable normal DCD usage*
DTR is ignored if AT&Q0 is selected. DTR ON-OFF
hangs up the terminal if AT&Q2 is selected.
25